Search for a command to run...

Haltech's interface for running a Gen 1 ZF 8HP from a drive-by-wire Nexus ECU. Previewed at SEMA 2026, planned for Q1 2027.
The Ti8HP connects a ZF 8HP to a Haltech Nexus ECU. Haltech is clear that it is "not a transmission controller": the gearbox's own control unit still decides the shifts, while the Ti8HP passes signals such as engine torque between the two.
It needs its own box because the two run different networks. The 8HP talks CAN at 500 kb/s and Haltech CAN runs at 1 Mb/s, so they can't share a bus. That also leaves a Haltech CAN port free for ABS, a body controller or a factory dash.
Not out yet
Haltech plans release in Q1 2027, with the date still to be confirmed, and says pre-orders aren't open yet. Features and prices below may change. Some retailers are already taking their own pre-orders.
* The Ti8HP reads the gearbox's original binary, then flashes the Haltech binary. Haltech says no third-party software or reflash tools are needed.
* The 8HP has no one-way clutches, so every downshift needs a throttle blip. That's why drive-by-wire is required.
If you can't wait for Q1 2027, or you have a Gen 2 or Gen 3 box, a T series or an Elite, these already work with Haltech:
Checked 8 November 2026 against Haltech's SEMA 2026 preview and Racing Solutions' write-up. Product image: Haltech.